FPGA cape for BeagleBone Black

 created a minimal FPGA cape for the BeagleBone Black:

BBB LX9 FPGA BoardIMG_6927a (1).png

Jim describes his design decisions:

I decided to try a minimalist hand solderable FPGA board.  The LX9 is the largest part available in a TQG-144, beyond that its BGAs

BBB-Fboard.png

One of the key points is that the SPI interface is on BBB pins which are accessible via PRU0.  This is important since the PRUs can be used to obtain higher performance SPI interfaces than the built in hardware units (examples herehere, and here).

The KiCad desgin files are available on GitHub:

drone32768/BREC

F-Pcb.png

The overall cost sourcing from OSHPark and Digikey is $12 for the PCB (quantity 3), LX9 $18 (quantity 1), connectors $3, oscillators, and regulators $3,  Flash and passives $3 for a rough total of $39 per board.

KiCad design files are available on GitHub:

BREC_3/Boards/Fboard

KD2BOA has shared the board on OSH Park: